To install the Samotics Connectivity Kit, please follow the steps listed below.
1. Install hardware on the DIN rail
1. Install hardware on the DIN rail
Mount the gateway, switch, and DAQ on the DIN rail.
Notice Make sure the DAQ is within 3 meters of the phase wires.
Warning Do not connect the system to the power grid during installation.
2. Connect earth bonding
2. Connect earth bonding
Attach the switch’s earth bonding point to the protective earth.
3. Connect Ethernet cables
3. Connect Ethernet cables
Use Ethernet port 1 on the switch and "Eth 2" on the gateway to connect them with the supplied cables.
Notice "COM" refers to the micro-USB port next to the Ethernet ports. The Ethernet ports are labeled "Eth 1" and "Eth 2".
4. Install the power supply
4. Install the power supply
Mount the power supply on the DIN rail.
Warning Do not connect the power to the 100-240V AC mains yet.
5. Connect the switch to power
5. Connect the switch to power
Use two 1.5 mm² wires to connect the switch to the power supply.
6. Connect the gateway to power
6. Connect the gateway to power
Use two 1.5 mm² wires to connect the gateway to the power supply.
7. Set up connectivity
7. Set up connectivity
Visit our Connectivity page for detailed instructions.